Skip to main content

ENGINEERING WRITTEN TEST QUESTIONS

Search This Blog

CIVIL, CHEMICAL, ENVIRONMENTAL, COMPUTER SCIENCE AND ENGINEERING QUESTION PAPERS AND ANSWER KEYS

September 06, 2015

Get link
Facebook
Twitter
Pinterest
Email
Other Apps

Civil Engineering Question Paper- Answer Key

Chemical Engineering Question Paper - Answer Key

Computer Science and Engineering Question Paper - Answer Key

Environmental Engineering Question Paper - Answer Key

Chemical Engineering Written Test Questions and Answers Civil Engineering Written Test Questions and Answers Environmental Engineering Written Test Questions and Answers

Get link
Facebook
Twitter
Pinterest
Email
Other Apps

Comments

Post a Comment

Popular Posts

ELECTRICAL ENGINEERING WRITTEN TEST QUESTIONS

1. Load factor is defined as the ratio of _________. (A) Connected load / Max. Demand. (B) Average Demand / Max. Demand. (C) Average Demand / Connected load. (D) Max. Demand / Average Demand. Answer: (B) Average Demand / Max. Demand. 2. The speed of an induction motor__________. (A) Decreases too much with the increase of load. (B) Increases with the increase of load. (C) Remains constant with the increase of load. (D) Decreases slightly with the increase of load. Answer: (D) Decreases slightly with the increase of load. 3. The frequency of the secondary voltage of a transformer will be_________. (A) higer than the frequency of the primary voltage. (B) Lesser than the frequency of the primary voltage. (C) Equal to the primary voltage. (D) Not Equal to the Frequency of the primary voltage. Answer: (C) Equal to the primary voltage. 4. When a low resistance is connected in parallel with a high resistance, the combined resistance is (A) B

ELECTRONICS AND COMMUNICATION ENGINEERING WRITTEN TEST QUESTIONS

1. In a forward biased pn junction diode, the sequence of events that best describes the mechanism of current flow is (A) injection, and subsequent diffusion and recombination of minority carriers (B) extraction, and subsequent drift and recombination of minority carriers (C) extraction, and subsequent diffusion and generation of minority carriers (D) injection, and subsequent drift and generation of minority carriers 2. A DC voltage source is connected across a series R-L-C circuit. Under steady-state conditions, the applied DC voltage drops entirely across the (a) R only (b) L only (c) Y (d) R and L combination 3.In an R – L –C circuit, the phase of the current with respect to the circuit voltage will be (A) Lagging. (B) Same. (C) Leading. (D) Depends upon the value of Land C. 4.In IC technology, dry oxidation (using dry oxygen) as compared to wet oxidation (using steam or water vapor) produces (A) superior quality oxide with a higher

Powered by Blogger